11
www.XSscuba.com
XS Scuba Inspire Regulator Service Manual
iii.Using circlip pliers, remove the circlip (4).
iv.Tap the yoke retainer (7) on a hard surface
and the filter (5) and its associated o-ring (6) should
come out. If it is stubborn and won’t drop out, use
the TL136 Multi-Purpose Tool to come in through
the backside of the yoke retainer (7) and push out
the filter (5) and its associated o-ring (6).
v. Remove the o-ring (8) from the underside of
the yoke retainer (7).
B. Inspire with DIN connector (Reference
exploded diagram with DIN version)
i. Remove the handwheel retainer (2) using a
6 mm hex key.
ii. Remove the handwheel (6), dust cap (9) and
saddle (10).
iii. Remove the two o-rings (1,3) found on each
side of the handwheel retainer (2).
iv. Remove the DIN housing (7) with a 13/16”
wrench or deep socket.
