Part 3: Preparing the Front Panel
XSpc
Page 9
Place panel [C] facing down on a
flat surface.
Take one of the [K] bay cage and
attach it using 6 countersunk
screws.
You will need to use a small
screwdriver due to limited space.
Repeat steps 2 and 3 for the other
side.
Flip the panel over and thread the
power cables through the hole on
the front.
On the reverse side place an o-
ring and nut over the switch then
tighten the nut.
1
2
3
4
5
6
Summary of Contents for H1 Cube+
Page 1: ...H1 Cube XSpc...
Page 19: ...XSpc...