Part 1: Preparing the Base Panel
XSpc
Page 7
Take panel [A] and place it on a
flat surface, protected by a clean
sheet.
Place a castor under a corner of
the panel and line up the 4 holes.
Put a screw through each hole.
On the underside of the panel
attach a washer and nut to each
screw and tighten using a
screwdriver.
Repeat the process for each of
the four castors.
Place the HDD cage over the
screw holes shown above.
Use four 6-32 thumb screws to
attach the HDD cage to the panel.
1
2
3
4
5
6
Summary of Contents for H1 Cube+
Page 1: ...H1 Cube XSpc...
Page 19: ...XSpc...
