DS800 Page 5
Front Panel Functions
1.
Isolated Outputs
– two identical transformer balanced outputs featuring high
voltage isolation, for use as broadcast or recording feeds or wherever
independent outputs are required. These connections are wired as follows :-
Pin 1 = No Connection, Pin 2 = Hot, Pin 3 = Cold.
2.
As Above
.
3.
Gain Switch
– sets the channel gain to +10dB, +20dB, +30dB, +40dB or
+50dB. See Mic/Line switch below.
4.
Mic/Line
– when in the ‘Line’ position the input is padded by 20dB and the input
impeadance changes to >10k Ohms.
5.
48V
– when selected applies 48V phantom power to the input XLR, for
condenser microphones or D.I. boxes. The LED is lit when active.
6.
Meter
– 5 segment level meter showing the level below clipping. Note: the red
LED lights up 6dB’s below actual clipping with a sine wave.
7.
Listen
– when selected the channel will be summed on to the ‘Solo’ bus, which
is routed to the headphone socket and ‘Solo Out’ XLR.
8.
Pad (-10dB)
– indicates 48V phantom power detected on the output ‘Mon’ XLR,
which will automactically switch in a 10dB pad on the channel.
9.
Headphone Level
– controls the level of the headphone output.
10.
Headphone Socket
.
11.
Power
– power indicator.
