9.
Verify operation of all lights and secure the harnesses with the provided cable ties.
Operation:
The System uses momentary switches to activate. Press Right or Left Actuator accordingly. Will cancel as
follows.
Press 1 Second for Lane Change, will stay on approx. 8 Seconds / 10 Flashes
Press 2 Seconds for Slowing to Turn Corners, will stay on approx. 20 Seconds / 30 Flashes
Press 5 Seconds for Traffic Lights when stopping and waiting, will stay on approx. 75 Seconds / 110 Flashes
The Systems Automatic Self-Cancelling may be overridden/Shut Off at any time by pushing the activated switch.
Hazard Lights - press to activate and press again to deactivate, it does not self-cancel.
Optional
- The Tan wire next to the Turn Switch is for an optional Dash Indicator. When the ATS is activated it will flash 12
VDC that can be attached to an Optional Dash Mounted LED Light, it is non-directional, flashes for both right and left
signals.
OPTIONAL: Using the rear turn lights as brake lights
- The orange wire coming out of the rear harness can be used to
activate the rear turn lights as brake lights for more visibility. To use, verify with a test light that your car uses positive
voltage to the brake lights when pressure is applied to the brake, if you get Positive voltage you may continue. Using the
provided Posi-Tap, tap the orange wire into the output side of the brake switch or to a brake light positive wire. Use the
Posi-Tap instruction above to attach the Brake Wire.
For more details on installation go to www.xtcinstall.com
We can also be reached by email at
XTC Power Products
A Division of XTC Motorsports LLC
925 N McQueen RD. #101
Gilbert AZ 85233
480-558-8588
*Disclaimer: This kit is intended for off road use only and XTC Motorsports claims no responsibility for its use. It is up to the purchaser to make sure it
complies with all Federal, State and Local laws.
R1
Copyright © 2019 XTC MOTORSPORTS LLC, all rights reserved.
