-8-
•
If setting mode has not been exited, you can change the calling mode by pressing KEY1 circularly.
•
The
LED_NAME
indicator will blink all the time until exit out the setting mode.
•
If without any operation in 10 seconds, it will exit out setting mode automatically.
•
In this step,press
KEY_SET
button three times to exit out the setting mode manually.
SETUP INSTRUCTIONS
* More details about code setting for monitor, please refer to corresponding user manual .
Each call button will respond different addresses when set in different calling mode. Refer to the
followings for more informations.
Call buttonA:
call the monitor with address
01
by default.
Call buttonB:
call the monitor with address
02
by default.
Call buttonC:
call the monitor with address
03
by default.
Call buttonD:
call the monitor with address
04
by default.
Call buttonE:
call the monitor with address
05
by default.
Call buttonF:
call the monitor with address
06
by default.
Call buttonG:
call the monitor with address
07
by default.
Call buttonH:
call the monitor with address
08
by default.
Call buttonA:
Call all monitors in group address from
00~15.(one of the monitor should be set to
00
)
Call buttonB,C,D,E,F,G,H:
Call all monitors in group
address from 16~31. (one of the monitor should be set to
16
)
UNLOCK Indicator:OFF
CALL Indicator:ON
Buzzer
Beep+, Beep
In standby mode, press
KEY_SET
button twice.
UNLOCK Indicator:OFF
CALL Indicator:ON
Buzzer
Beep+
Press
KEY_1
button to
activate
Standard calling
mode for door station.
UNLOCK Indicator:OFF
CALL Indicator:ON
Buzzer
Beep, Beep
Press
KEY_1
button again
to activate
Group calling
mode for door station.
Press
KEY_1
A
B
C
D
E
F
Apartment system
door station
Villa system door station
B
A
G
H
RF CARD
RF CARD
1.Standard calling mode(Address range 01-08 by
default)
2.Group calling mode
To change this setting, please follow the steps:
