- 18 -
Click OK and the WAN IP will appear in the IP address bar.
12) Advance:
DNS Server Address1: The IP address of the DNS server.
DNS Server Address2: The standby IP address of the DNS server.
Alarm Host IP: Enter the IP address of the alarm host.
Alarm Host Port: Enter the port of the alarm host.
Enable PPPOE: you can enable the PPPOE service:
input the PPPOE user name.
input the dynamic address of the device.
confirm password.
[DDNS Settings]
Through the DDNS server, there should be a PC with fixed
IP address on the internet and run this DDNS server on this PC.
1)
Select DDNS server type(There are Ip Server, Dyndns, Peanuthull for
selection).
2)
Input the server name.
3)
Input the port.
4)
Input the user name.
5)
Input the password.
6)
Confirm the password.
7)
Input the standby domain name.
[NTP Settings]
Enable NTP timing.
1)
Server Address: Input the IP of the NTP server.
2)
NTP Port: This SNTP only supports TCP transmission. It is default to
123.
3)
Synchronize every: Input the time interval needed to be adjusted.
4)
Select Time Zone: Select the time zone of different places.
5)
GMT: You can do fine adjustment of time.
[Email Settings]
Setup E-mail.
1)
Email Address: Input the email address.
2)
Password: Input the email password.
3)
Pwd Confirm: Confirm the password.
4)
Receiver: Input the email address and user name of the receiver.
5)
Interval : Select the interval of sending email.
6)
SMTP Server: Input the SMTP server address.
