XtendLan G.SHDSL.bis Router XL-GRT402S, XL-GRT404S, User Manual
configure NAT. See
Configuring NAT
Section
If you want to set up a global address pool on your existing NAT enabled interfaces:
1.
From the
NAT Security Interfaces
table, click on the
Advanced NAT Configuration
hyperlink for the interface that you want to add a global pool to. The following page is
displayed:
2.
Click on
Add Global Address Pool.
The following page is displayed:
3.
This page allows you to create a pool of network IP addresses that are visible
outside your network. Add values for the following table entries:
•
Interface type
; the internal address type that you want to map your external global
IP addresses to. Click on the drop-down list and select an interface type.
•
Use Subnet Configuration
; there are two ways to specify a range of IP addresses.
You can either
Use Subnet Mask
(specify the subnet mask address of the IP
address) or
Use IP Address Range
(specify the first and last IP address in the range).
Click on the drop-down list and select a method.
• type in the
IP Address
that is visible outside the network
•
Subnet Mask/IP Address 2
; the value you specify here depends on the subnet
configuration that you are using. If you chose
Use Subnet Mas
k, type in the subnet
mask of the IP address. If you chose
Use IP Address Range
, type in the last IP
-36-
