40
Chapter4 WAN Access
The IP protocol supports WAN access based on PPPoE dial up function. Make sure that the software
you are using suppo rts the func tion before using these network functions.
4.1 Dial Up With PPPoE
Make sure that the user name and password of PPPoE are set correctly by the client software (refer to
“User Manual of Network Digital Surveillance Software”) as Fig.4.1. The camera will try to establish
connection to the network with PPPoE function automatically every time when it is po wered on, and get a
dynamic IP addr ess by then.
Fig.4.1 Dial Up with PPPoE
【
Notice
】
Please make sure that the ADSL Modem is powe red on .The camera needs to be restarted
to establish the network connection afte r the configuration of PPPoE parameters for the first time.
And XL-ICA-105M2 do not support this function.
4.2 WAN Access
There are two methods to get the access, which are shown as be low.
1. Get a static IP from your ISP for WAN access.
You can open some po rts (such as 80 & 8000 ports) in the router which has got static IP from the ISP,
and then connect the m to the router. After that you can use the client software to control it. Turn to ch3.2 to
find the client software operations.
Attention:
XL-ICA-105M2 network camera need to open RTSP port 554, other than open 80 &
8000 ports.
2. Use DNS service for WAN access.
You will need a PC connected to Internet with static IP that owns software providing DNS service at
the same time(such as IP Server)(the PC is so-called DNS server).You can also register a domain name
through the DNS service dealer and visit it with the domain name.
