3. NMS (network management system) Configuration. The corresponding configuration need to be done so
that the NC can be monitored through NMS. For example, The given IP address is 10.86.5.100, and the
subnet mask is 255.255.252.0, management is VLAN 52, SNMP’s community name is test.
GD.LINK>
enable
/*access initial mode*/
Password
: admin
/*enter password*/
GD.LINK#
configure terminal
/*access overall configuration mode*/
GD.LINK(config)#
snmp community test
/*configure SNMP parameter’s community name to be test*/
GD.LINK(config)#
snmp server start
/*enable SNMP server*/
GD.LINK(config)#
interface manage-interface
/*access interface configuration mode*/
GD.LINK(config-if)#
ip-address 10.86.5.100/22 gateway 10.86.4.1
/*configure IP address to be 10.86.5.100, 22 represents the
subnet mask bits, 10.86.4.1 is default gateway address*/
GD.LINK(config-if)#
vlan 52
/*configure the management VLAN as Vlan 52*/
GD.LINK(config-if)#
end
/*back to privilege configuration mode*/
GD.LINK#
write
/*save the configuration*/
GD.LINK#
show running-config
/*check the finished configured program*/
configure terminal
snmp community test
snmp server start
exit
configure terminal
end
configure terminal
interface manage-interface
ip-address 10.86.5.100/22 gateway 10.86.4.1
vlan 52
exit
end
configure terminal
port coax
exit
end
configure terminal
headend
exit
end
