Rec Room Masters www.recroommasters.com
email: support@recroommasters.com
page 2
UNBOXING YOUR CONTROLLER
STEP 1: Carefully unpack your arcade control board. If you use a utility knife, please make
sure you do not damage any part of the product when unpacking.
STEP 2: Once unpacked, attach your controller to your 32” Xtension Arcade cabinet or
Pedestal and secure with the 4 - 60mm black bolts using the Allen wrench that was included
with your cabinet. If you did not order an Xtension Arcade cabinet, you will not need the 4 -
60mm black bolts.
STEP 3: Your Xtension Emulator Edition Controller has 1 USB cable. Plug your USB cable into
your PC, Mac or Raspberry pi and turn on your computer or pi. Your LED Menu buttons will
turn on and are powered by the USB input of your PC, Mac or Raspberry pi.
3 SWITCHABLE MODES
There are 3 different switchable gameplay modes for your controller. You can switch between
the 3 available modes by simply holding down player 1 start and an additional assigned
mode button for 10 seconds. That’s it! After 10 seconds, release both buttons and wait up to
30 seconds for the desired mode to take effect. The assigned mode will save and open when
restarting your system.
Your 3 mode options are Keyboard Mode, D-Input and X-Input. The controller will normally
ship with Keyboard mode defaulted . You can change to your desired mode without any 3rd
party software or firmware update. Use Keyboard Mode for Trackball use.
NOTE: The menu names labeled on the controller’s graphic are only for Keyboard Mode.
See the helpful video linked below on how to switch modes.
HOW TO SWITCH MODES:
https://youtu.be/d8jbvclHkkk
KEYBOARD MODE
Keyboard Mode is best used for PC Emulators , MAME and popular front end software like
Hyperspin and Launchbox. The Menu buttons functionality is VERY important for emulation
and navigation with PC emulators and front end software. Keyboard mode is the only
mode where you can access this full menu navigation feature and we highly recommend
this mode for use with PC Emulators, MAME, Hyperspin, LaunchBox and most PC arcade
front end software. The Keyboard mode is defaulted to the popular MAME software and we
recommend mapping all of your emulators to Keyboard mode when using a PC.
