Xtensions XC-722, User Manual

GB

8

 

Ensure the power inverter is sufficiently 

ventilated - ventialtion slots must NOT be 

covered up.

Ensure  you  do  not  overload  the  power  in-

verter.  Only  connect  electrical  units  that 

draw a maximum of 300W. The rated power 

of a unit can be found on the mains adapter 

or in the unit’s handbook.

Operation

CAUTION: Once the unit is connected there 

will be a 230V power supply to the output 

socket. On no account should you touch the 

socket contacts. Keep the socket out of re-

ach of children and do not allow the power 

inverter to come into contact with water or 

any other liquids.

On/Off switch

Note:

  Only  use  the  power  inverter  in  the 

vehicle  when  stationary???.  Jöllenbeck 

GmbH  accepts  no  liability  whatsoever  for 

either the use of the unit whilst in motion or 

for fixed installation of the power inverter in-

side the vehicle.

 

Before using the power inverter flick the 

On/Off switch to position I.

 

Flick the On/Off switch to position 0 if 

you are not using the power inverter. 

This prevents unnecessary current being 

drawn from the car battery.

LEDs

 

The Power LED (above) shows that the 

power inverter is working correctly.

 

The Fault LED shows that there is a 

fault. Should the Fault LED illuminate, 

flick the On/Off switch  to position 0 and 

then back again to position I. If the LED 

continues to illuminate check the fuse. 

Further information about this can be 

found in the chapter “Changing the fuse“.

Changing the fuse

Remove both screws on the fuse cover, then 

remove the fuse cover. Remove the old fuse 

and  replace  it  with  a  new  one.  Make  sure 

you fit a fuse rated at 40A maximum.

Technical Data

 

Model no: XC-722

 

Input voltage: 12 Volt

 

Output voltage: 230 Volt

 

Maximum power output: 300 Watt

 

Active cooling