Customer Service 1-888-707-1880
Dyaco Canada Inc. 2014
Email: customerservice@dyaco.ca
27
General Maintenance
WARNING: Always unplug your treadmill prior to cleaning in order to avoid
electrical hazard or shock.
Belt and Bed
-
Your treadmill uses a very high-efficient low-friction bed. Performance
is maximized when the bed is kept as clean as possible. Use a soft, damp cloth or
paper towel to wipe the edge of the belt and the area between the belt edge and
frame. Also reach as far as practical directly under the belt edge. This should be done
once a month to extend belt and bed life. Use water only - no cleaners or abrasives. A
mild soap and water solution along with a nylon scrub brush will clean the top of the
textured belt. Allow to dry before using.
Belt Dust
-
This occurs during normal break-in or until the belt stabilizes. Wiping
excess off with a damp cloth will minimize buildup.
General Cleaning
-
Dirt, dust, and pet hair can block air inlets and accumulate on the
running belt. On a monthly basis, vacuum underneath your treadmill to prevent buildup.
Once a year, you should remove the black motor hood and vacuum out dirt that may
accumulate
.
UNPLUG POWER
CORD BEFORE THIS TASK.
Cleaning metal surfaces may be accomplished by using a soft cotton or terry cloth rag
with a light application of car wax. Do not use aerosol sprays or pump bottles as they
may deposit wax upon the walking or computer surface. Under no circumstances are
you to use ammonia, oils, silicones, or any other compounds on the rubberized walking
surface. The use of such materials may cause serious injury to the body and/or
deteriorate the performance of the walking surface. Only clean the rubberized walking
surface with a damp cloth (water only). From time-to-time the computer surface may
collect dust or finger prints. The use of harsh chemicals will destroy the protective
coating and cause a static build up that will damage the components. This surface may
be cleaned with specially prepared chemicals found in most computer supply stores
especially made for anti-static surfaces. It is strongly recommended that you purchase
such a cleaning compound.
TREADMILL LUBRICATION
Your treadmill should require little maintenance other then periodically applying lubricant.
Lubricating under the treadbelt will ensure superior performance and extend its life expectancy.
HOW TO CHECK IF THE TREADBOARD REQUIRES LUBRICATION
Lift one side of the treadbelt and feel the top surface of the treadboard
If the surface is (slick) to the touch, then no further lubrication is required
If the surface is dry to the touch, apply one packet of lubricant or half of the bottle of lubricant.
