8
FS3.5 Elliptical
#76
. 5/16 x 1-3/4
Hex Head Bolt (6 pcs)
#87
.
Ø
3.5 x 12mm
Sheet Metal Screw
(8 pcs)
#91
. 5/16 x 7T
Nyloc Nut (6 pcs)
#113
. 5/16” x 23 x 1.5T
Curved Washer
(4 pcs)
Conecting Arm Assembly
4
Hardware Step 4
1. Connect the Swing Arm (
L
) (
15
) to the left Lower Handle Bar and con-
nect the Swing Arm (
R
) (
16
) to the right Lower Handle Bar, and secure
them with six Hex Head Bolts (
76
), four Curved Washers (
113
) and six
Nyloc Nuts (
91
) by using 12m/m Wrench (
116
) 13.14m/m Wrench (
115
).
2. Put the Front Handle Bar Cover (
L
) (
69
) and the Rear Handle Bar Cover
(
L
) (
69-1
) together on the left Handle Bar and secure with three Sheet
Metal Screws (
87
) by using Combination M5 Allen Wrench & Phillips
Head Screw Driver (
118
). Repeat the same procedure for the right side.
3. Connect the Console Mast Cover (
L
)(
42
) and the Console Mast Cover
(
R
)(
43
) together on the Console Mast and secure with two Sheet Metal
Screws (
87
) by using Combination M5 Allen Wrench & Phillips Head
Screw Driver(
118
)