8
3
Connecting Arms & Rear Rails
Hardware Step 3
#71
. 5/16” x 32mm
Hex Head Bolt (2 pcs)
#76
. 5/16” x 3/4”
Button Head Socket
Bolt (2 pcs)
#77
. 3/8” x 2-1/4”
Button Head Socket
Bolt (2 pcs)
#89
. 3/8” x 7T
Nyloc Nut (2 pcs)
#94
. 3/8” x 19 x 1.5T
Flat Washer (2 pcs)
#98
. 5/16” x 20 x 1.5T
Flat Washer (4 pcs)
#105
. 5/16” x 7T
Nyloc Nut (2 pcs)
1. Insert the Rail Tubes (
15
) into the bracket on the back side of the main
frame. Secure each tube in place with a Button Head Socket Bolt (
77
),
a Flat Washer (
94
), and a Nyloc Nut (
89
). Tighten with the M5 Allen
Wrench/Phillips Head Screw Driver (
108
) and the Wrench (
111
). Insert
the curved ends of the Rear Handle (
16
) into the slot on each of the
Rear Rail Stabilizers (
62
). Set in place on the rear of the Rail Tubes (
15
).
Secure with two Button Head Socket Bolts and two Flat Washers (
98
).
Tighten with the M5 Allen Wrench/Phillips Head Screw Driver (
108
).
2. Remove the wire tie that holds the spacer into the rod end of the Right
Connecting Arm (
8
). Connect the Lower Right Swing Arm (
5
) to the
Connecting Arm (
8
) by sliding the Hex Head Bolt (
71
) through the
bracket on the lower swing arm and the spacer in the rod end of the
connecting arm. Secure in place with the Flat Washer (
98
) and the Nyloc
Nut (
105
). Tighten with the Wrenches (
110
&
111
).
3. Repeat the previous step on the left side.
Summary of Contents for FS4.0e
Page 1: ...OWNER S MANUAL PLEASE CAREFULLY READ THIS ENTIRE MANUAL BEFORE OPERATING YOUR NEW ELLIPTICAL ...
Page 2: ......
Page 21: ...19 Exploded View Diagram ...
Page 25: ...23 ...
