8
FS5.9e Elliptical
#99
. 5/16” x 15mm
Hex Head Bolt (2 pcs)
#101
. 5/16” x 1-1/4”
Hex Head Bolt (2 pcs)
#127
. 5/16” x 7T
Nyloc Nut (2 pcs)
#141
. 5/16” x 23 x 1.5T
Flat Washer (2 pcs)
#142
. 5/16” x 20 x 1.5T
Flat Washer (2 pcs)
#150
. 17mm
Wave Washer (4 pcs)
2
Hardware Step 2
1. Slide two wave washers (
150
) onto each side of the swing arm axle.
Slide the lower swing arms (
10
Left,
11
Right) onto the axles and secure
with the two Hex Head Bolts (
99
) and Flat Washers (
141
).
Do not force
the swing arms onto the axle. They should slide on, but you may need
to jiggle them to get them lined up properly. The swing arms have been
previously installed at the factory so they do fit properly.
2. Remove the tie that holds the spacer (
25
) in the rod end located at the
end of the right connecting arm (
9
) and line up the rod end with the
bracket at the bottom of the lower right swing arm (
11
). Slide the Hex
Head Bolt (
101
) through the bracket of the lower swing arm and then
through the rod end. Install the Flat Washer (
142
) and Nyloc Nut (
127
)
on the bolt and tighten as much as possible. Repeat this step for the left
side.
Connecting & Lower Swing Arms
