FS5.9e Elliptical
9
#127
. 5/16” x 7T
Nyloc Nut (6 pcs)
#159
. 5/16” x 1-3/4”
Hex Head Bolt (6 pcs)
#160
. 5/16” x 23 x 7T
Curved Washer (4 pcs)
#161
. Switch Wire
Cap (2 pcs)
3
Hardware Step 3
1. Slide the Rubber Sleeve (
162
) onto the left (
16
) and right (
17
) Upper
Swing Arms. Make sure the wide part is at the bottom.
2. Attach the wire (
166
) from the left Upper Swing Arm (
16
; Incline buttons
on front) to the wire (
167
) that exits the Console Mast Tube (
12
). Slide
the switch wire cap (
161
) onto the wire with the wide side facing the
Swing Arm.
3. Insert the Upper Swing Arm (
16
) into the Lower Swing Arm. Fasten
together with three Hex Head Bolts (
159
) and two Curved Washers
(
160
).
4. Repeat steps 3.2 & 3.3 from above on the right side. You will connect
wires (
165)
to (
167)
.
Upper Swing Arms
