Xterra SB540r Bike
8
STEP 1: SEAT ASSEMBLY & REAR STABILIZER
•
Install the
rear stabilizer tube
(18) and secure with two 3/8 Carriage bolts (96), 3/8
curved washers (97) and 3/8 cap nuts (98).
•
Sitting next to the unit with the
seat post
(11) in your lap, connect the two wires together
(109 & 110). Secure the seat post to the main frame be careful to not pinch the wires
with the six 5/16 x 3/4 bolts (95), 5/16 split washers (73) and 5/16 flat washers (70).
•
Lay the
seat cushion
(52) on the floor, cushion side down, and then lay the seat carriage
assembly (4 &14) on top of the seat cushion. Align the holes and secure the seat cushion
with four M6 x 15mm screws (99).
Make sure seat cushion is facing the right direction.
•
Secure the
seat carriage assembly
(4 &14) to the seat post with four 5/16 x 1-1/4 bolts
(90).
Make sure these bolts are very tight.
Assemble the plastic end caps (42) to the seat
carriage with four M5 x 12mm screws (81).
Assembly Instructions
for
Xterra SB540r
Summary of Contents for SB540r
Page 1: ...OWNER S MANUAL...
