TR6.6 Treadmill
7
Upright Tubes
3
1. Attach and center a Speed Nut Clip (
132
) over the open hole of base
frame.
2. Slide the Right Console Mast Tube (
4
) into the Base Frame. Gently pull
up the Computer Cable that exits the top of the tube as you slide it in to
prevent pinching the cable. If the cable is pinched and partially severed,
the treadmill’s electrical system won’t function properly. Repeat the
process on the left side (you don’t have to worry about a cable on this
side).
3. Partially tighten all six Button Head Bolts (
93
) that are inserted from the
sides, and two Curved Washers (
94
) and two Button Head Bolts (
93
)
from the front with the Combination Allen Head Wrench & Phillips Head
Screw driver (
96
). Don’t fully tighten these until the Console is attached.
94
93
93
94
93
93
5
4
132
132
132
132
Hardware Step 3
#93
. 5/16” x 15mm
Button Head Socket
Bolt (8 pcs)
#94
. 5/16”
Curved Washer (2 pcs)
#132
. M5
Speed Nut Clips
(4 pcs)
