TR3.0 Treadmill
13
The 1/4-mile track will be displayed around the dot matrix window. The flashing dot indicates
your progress. Once the 1/4-mile is complete the next lap will begin. The number of
completed laps is displayed in the Laps window.
1/4 Mile Track
The Pulse (Heart Rate) readout will display your current heart rate in beats per minute
during the workout. You must use both stainless steel sensors on the side hand rails to
display your pulse. Pulse value displays anytime the upper display is receiving a Pulse
signal.
Pulse Grip Feature
Displays the cumulative calories burned at any given time during your workout.
Note
: This is only a rough guide used for comparison of different exercise sessions, which
cannot be used for medical purposes.
Calorie Display
1. Display will automatically turn off (go to sleep) after 30 minutes (no key operations). The
treadmill will draw very little current in sleep mode (about as much as your television when
it is turned off).
2. Remove tether cord.
3. Turn of the main switch on the front of the treadmill, below the motor cover.
To Turn Treadmill Off
Attention
Your new console comes configured in an in-store ‘Display Mode’ of operation, where the
console will remain powered on unless the main power switch is turned off. To exit the display
mode, for normal operation, press and hold the
Stop
,
Enter
and
Display
keys for 5 seconds;
the display will show: Display mode - On. Use the
Incline
5
/
6
key or the
Speed
5
/
6
key to
change the setting to Off then press
Enter
.
Summary of Contents for Trail Racer TR3.0
Page 27: ......
