Xterra Trail Racer TR3.0, Owner'S Manual

TR3.0 Treadmill

23

The console has built in maintenance/diagnostic software. The software will allow you to 

make changes to the console settings such as changing units from English to Metric or turn-

ing off the console beeps (if they are waking your family during your early morning workouts). 

To enter the Maintenance Menu (may be called Engineering Mode, depending on version) 

press and hold down the 

Start

, 

Stop

 and 

Enter

 keys. Keep holding the keys down for about 

five seconds and the message window will display “Engineering Mode”. Press the 

Enter

 key 

to access the menu below. Press the 

5

/

6

 keys to navigate the menu. 

a.  Key Test - Allows you to test all the keys to make sure they are functioning

b.  Display Test - Tests all display functions

c.  Functions - Press 

Enter

 to access settings, use 

5

/

6

 keys to navigate.

i.  Sleep Mode - On; when turned on the console will darken after 30 minutes of no use. 

When turned off the console will remain lit as long as the power is on

ii.  Display Mode - Turn off to have the console power down automatically after 30 min-

utes of inactivity; leave on to display all lights while the power is on

iii.  Pause mode – On; when turned off, pressing 

Stop

 once ends the program; when 

turned on, the  

console retains data for five minutes before switching to the startup screen

iv.  Odometer Reset - Reset the odometer 

v.  Units - Set to English or Metric display readings

vi.  Motor Test - Continually runs the tensioning gear motor

d.  Security - Allows you to lock the keypad so no unauthorized use is allowed. When the 

child lock is enabled, the console will not allow the keypad to operate unless you press 

and hold the 

Start

 and 

Enter

 keys for three seconds to unlock the console.

e.  Factory Settings

To save and exit, press the 

Stop

 key

Error Messages

LS:

 The treadmill hasn’t received a speed signal for 8 seconds.

E1:

 Console memory malfunction or CPU problem.

E2:

 Incline position error.

Engineering Mode