4
UB1.5 Upright Bike
1. Locate the Console Mast (
2
) and slide on the Console Mast Cover (
48
).
Make sure the cover is facing the correct direction, as shown below,
before sliding onto mast. Install the wiring harness (
39
) into the bottom
of the mast and out the top. Be careful when installing the console mast
to the mainframe so as not to pinch or cut the wiring harness; damage to
the electronics may occur.
2. Install the console mast onto the mainframe with five Button Head
Socket Bolts (
26
), five Split Washers (
29
), four Flat Washers (
27
), and
one Curved Washer (
28
). Tighten using the M5 Allen Wrench (
33
). Snap
the Console Mast Cover (
48
) in place against the plastics below.
3. Secure the Front Stabilizer (
4
) and Rear Stabilizer (
5
) to the frame with
four Button Head Socket Bolts (
26
), four Split Washers (
29
), and four
Flat Washers (
27
). Tighten using the Combination M5 Allen Wrench &
Phillips Head Screw Driver (
33
).
UB1.5
Assembly Instructions
Hardware Step 1
Stabilizer Tubes & Console Mast
#26
. 5/16” x 3/4”
Button Head Socket
Bolt (9 pcs)
#27
. 5/16” Flat
Washer (8 pcs)
#28
. 5/16”
Curved Washer
(1 pc)
#29
. 5/16”
Split Washer
(9 pcs)
1
