REVERSIBLE [SEE FIG.E]
FIG.E
The forward/reverse rotation control located above the On/Off switch controls the
direction of rotation. For drilling and screw driving use forward rotation marked
“
”(lever is moved to the left).Only use reverse rotation marked “
”
（
lever is
moved to the right
）
to remove screws or release a jammed drill bit.
When the selector is in the center position, the switch is locked.
Torque adjustment
(Screw driving force of your drill driver)
The torque is adjusted by rotating the torque adjustment ring. The torque is greater
when the torque adjustment ring is set on a higher setting. The torque is less when
the torque adjustment ring is set on a lower setting.
Make the setting as follows
1-3 for driving small screws
4-7 tightening of screws in soft types of materials (wood, gypsum)
8-11 tightening screws in soft and solid types of materials (wood, gypsum, sheet
metal)
12-15 for driving screws in solid wood
16-18 for driving of large screws
for heavy drilling
CHARGER PROCEDURE
NOTE:
Before using the tool, read the instruction book carefully.
RECHARGING BATTERIES
A) CHARGING THE BATTERY
To the Li-ion battery installed in the machine, do not use another battery charger.
The Li-ion battery is protected against deep discharging, when the battery is empty,
the machine is switched off by means of a protective circuit - the chuck no longer
rotates.
In a warm environment or after heavy use, the battery pack may become too hot.
Allow time for battery to cool down before recharging.
FIG.A
