TIP!
•
Even if you tighten the tool in the chuck fully and with all your strength, it is still not
locked
and it can theoretically come loose during work. To lock the tool in the chuck, turn counter-
clockwise and tighten until you hear a characteristic "
clicking
" sound. Tighten the chuck as
far as it will go and then gently rotate it back to the other side until you hear
one distinct
"click" sound
. Now the tool is locked in the chuck and ready for work.
BUCKLE INSTALLATION
The clip is suitable for temporarily hanging the tool, e.g. on a work belt, strap, etc. The clip can be
installed on the right side of the drill base. To install the clip, insert it into the groove in the body of
the drill and then secure it with a screw (see picture below). To remove the clip, loosen the screw
and simply remove it.
1. Groove
2. Buckle
3. Screw
PROPER TOOL HANDLING
Hold the tool firmly with one hand on the handle and the other hand on the bottom of the battery
for a firm and secure grip on the device.
1. Ventilation slots
CAUTION!
•
Try not to cover the ventilation openings (1) with your hand during use. The device could
overheat.
Summary of Contents for XT102705
