XTline XT102768, User Manual

1 

1. Knob

FUNCTIONAL  DESCRIPTION

CAUTION: Always be sure that the tool is  switched 

off and the battery cartridge is removed before 

adjusting or checking function on the tool.

Adjusting the angle of the worklight CAUTION: 

Hold the tool firmly when changing the angle of 

worklight. Failure to hold the tool  firmly may cause 

it to slip off your hands  and result in damage to the 

tool and a personal  injury. 

Loosen the knobs anticlockwise on the both side. 

Adjust the angle of  the worklight to the desired  

position .Then tighten the knobs clockwise again. 

Total 120°angle is permitted. 

Lighting up the  light 

1. To light up the light, press down the power switch to

the “ I ” position, then the light shines brightly

(high mode); press down the power switch to the “II ”

position, then the light shines mildly (low mode).

2. To  light off  the light, press down the power switch

to the “O(Middle)” position.

1 

CAUTION: Do not look in the light or see the 

source of light  directly. 

Battery protection system 

The tool is equipped with the protection system, which automatically cuts off the output 

power for long service life. The light goes off during operation when the  remaining battery 

capacity gets low. This is caused by  the activation of the protection system and does not  

show trouble. Remove the battery cartridge from the  tool and charge it. 

1 

1. Hex bolts

Adjusting the angle of the handle 

Use hex wrench to loosen the hex bolts anticlockwise on the 

both side. Adjust the angle of  the handle to the desired  

position .Then tighten  the bolts clockwise again. 

MAINTENANCE

CAUTION: Always be sure that the tool is  switched off and 

the battery cartridge is removed before attempting to perform 

inspection or  maintenance. 

NOTICE: Never use gasoline, benzine, thinner,  alcohol or 

the like. Discoloration, deformation or  cracks may result. 

To maintain product safety and reliability, repairs, any other 

maintenance or adjustment should be performed by  

authorized Factory or service centers, always using original 

replacement parts. 

Cleaning

From time to time wipe off the outside (tool body) of the  tool using a cloth 

dampened in soapy water. 

1. Power switch

Working time with

2,0Ah

battery

 - 

approx

1h

.