4.
Switch on the motor only when hands and feet are away from the nylon cutting head.
5.
Before starting make sure that the nylon cutting head has no contact with hard objects such as
branches, stones etc. as the nylon cutting head will revolve when starting.
6.
Remove any adjusting key, wrench or blade cover before turning the power tool on. An accessory
left attached to a rotating part of the power tool may result in personal injury.
Method of operation
1.
Only use the tool in good light and visibility. During the winter season beware of slippery or wet
areas, ice and snow (risk of slipping). Always ensure a safe footing.
2.
Take care against injury to feet and hands from the nylon cutting head.
3.
Never cut above waist height.
4.
Never stand on a ladder and run the tool.
5.
Never climb up into trees to perform cutting operation with the tool.
6.
Never work on unstable surfaces.
7.
Remove sand, stones, nails etc. found within the working range. Foreign particles may damage the
nylon cutting head.
8.
Should the nylon cutting head hit stones or other hard objects, immediately switch off the motor
and inspect the nylon cutting head.
9.
Before commencing cutting, the nylon cutting head must have reached full working speed.
10.
During operation always hold the tool with both hands. Never hold the tool with one hand during
use. Always ensure a safe footing.
11.
The nylon cutting head has to be equipped with the guard. Never run the tool with damaged guards
or without guards in place!
12.
All protective equipment such as guards supplied with the string trimmer must be used during
operation.
13.
Except in case of emergency, never drop or cast the tool to the ground or this may severely
damage the tool.
14.
Never drag the tool on the ground when moving from place to place, the tool may become
damaged if moved in this manner.
15.
Always remove the battery packs from the tool:
−
whenever leaving the tool unattended;
−
before clearing a blockage;
−
before checking, cleaning or working on the tool;
−
whenever the tool starts vibrating abnormally;
−
whenever transporting the tool.
16.
Always ensure that the ventilation openings are kept clear of debris.
17.
Hold the power tool by insulated gripping surfaces only, because the cutter blade may contact
hidden wiring. Cutter blades contacting a "live" wire may make exposed metal parts of the power tool
"live" and could give the operator an electric shock.
Maintenance instructions
1.
The condition of the nylon cutting head, protective devices must be checked before commencing
work.
2.
Turn off the motor and remove the battery packs before carrying out maintenance, replacing the
nylon cutting head or nylon cord and cleaning the tool.
3.
Check for loose fasteners and damaged parts such as cracks in the nylon cutting head.
4.
Follow instructions for lubricating and changing accessories if applicable.
5.
When not in use store the equipment in an indoor dry location that is locked up or out of children's
reach.
6.
Use only the manufacturer's recommended replacement parts and accessories.
7.
Inspect and maintain the tool regularly, especially before/after use. Have the tool repaired only by
our authorized service center.
8.
Keep handles dry, clean and free from oil and grease.
WARNING:
DO NOT let comfort or familiarity with product (gained from repeated use) replace strict adherence to
safety rules for the subject product. MISUSE or failure to follow the safety rules stated in this instruction
manual may cause serious personal injury.
Summary of Contents for XT102880-2B2
Page 10: ......
