PROBLEM SOLVING
PROBLEM
CAUSE
SOLUTION
The engine stopped running
-
Disconnected power
supply
-
The plug is not fully
connected
-
faulty switch
-
Defective carbon
-
Connect to the switch
-
Check the plug
-
Replace carbon
Slow engine running,
power on
-
The switch is off
-
Mechanical defect
-
Replace the switch
-
Check the mechanical
parts
Slow running, noisy run
-
Worn disc
-
The disc hit the
obstacle
-
Replace with a new one
-
Try another place to cut
Electric tool handling and maintenance
-Do not force the tool.
-Do not use if the ON/OFF switch does not work properly.
-Disconnect the plug from socket and/or battery from the tool prior any adjustment, accessory replacement or
storage of tool. These preventive safety precautions reduce a risk of accidental starting of tool.
-When not in use, idle tools should be stored in a place out of reach of visitors and children.
-Maintain careful manipulation with the tool. Check for deflecting or jamming of turning parts, damaged parts
or other conditions which may influence operating with the tool.
-Keep tools sharp and clean for better and safer performance. Properly serviced tools are less likely to become
covered in impurities and are better controlled.
-Use equipment recommended by the producer of your model only. Modifications and accessories used at one
tool may be dangerous when used with another model.
