XTM Racing Mammoth, Operation Manual

6

Visit our website at http://xtm.globalhobby.com or for Customer Service at http://globalservices.globalhobby.com

Now that you are familiar with the major component parts of your Mammoth RTR Nitro Monster Truck, and with the functions of the Hitec
Lynx Sport transmitter, it's time to prepare your Mammoth RTR Nitro Monster Truck for its first run.

✦

✦

✦

✦

✦

IMPORTANT

✦

✦

✦

✦

✦

  Before continuing, please double-check that you've read and understand the warnings printed on page # 2.  It's

important that you understand this information before preparing to run your Mammoth RTR Nitro Monster Truck.  Also, remember, if
you have any questions or encounter any problems, you can contact us using the information listed near the bottom of page # 2.

❑

Push the antenna down into the molded hole in the top of the transmitter.

❑

Thread the antenna (clockwise) into place and tighten it 

gently

 until it stops.

✦

✦

✦

✦

✦

IMPORTANT

✦

✦

✦

✦

✦

  Do not force the antenna into place or tighten it too strongly.  Doing

so could cause damage to the antenna and/or transmitter.

❑

Remove the plastic battery cover from the bottom of the transmitter.

❑

Install 8 AA Alkaline batteries into the battery tray, double-checking to make sure that

the polarity is correct.

❑

Reinstall the battery cover and set the transmitter aside for now.

❑

Open the battery box cover by pushing on the molded tab at the back of the battery

box cover and lifting up on the back of the cover.  The battery box cover is hinged at the
front for convenience.

❑

Remove the battery holder from the battery box.

✦

✦

✦

✦

✦

IMPORTANT

✦

✦

✦

✦

✦

  You may need to temporarily remove the receiver to get to the battery

holder.  Don't unplug anything from the receiver.  The battery holder plug has already
been plugged into the switch.  Do not unplug it when removing the batter holder.

❑

Install 4 AA Alkaline batteries into the battery holder, double-checking to make sure

that the polarity is correct.

✦

✦

✦

✦

✦

IMPORTANT

✦

✦

✦

✦

✦

  Make sure that the batteries are pushed firmly into place.  They

should not be loose.  If for any reason the plug from the battery holder is not plugged
into the switch plug, plug them together now.  The plugs can fit together only one way.

SECTION 4:  PREPARING TO RUN YOUR MAMMOTH RTR NITRO MONSTER TRUCK

Step 1:  Final Assembly