Page
step 3: installing the antenna suppoRt tube
q
Uncoil the receiver antenna.
q
Push the end of the antenna up through the antenna mounting hole in the
battery cover.
q
Slide the receiver antenna wire into one end of the antenna support tube
and out the other end.
iMpoRtant
If you have difficulty sliding the antenna wire through the antenna support tube in the next procedure, first pull the
antenna wire through your fingers several times to straighten it, then lightly wet the antenna wire with glass cleaner. The glass cleaner
will make the antenna wire slide through the support tube much easier.
q
After the battery has finished charging, reinstall it into the chassis and
reinstall the battery cover, using the two clips provided.
iMpoRtant
Don't plug the battery into the speed controller yet.
q
Push the end of the antenna support tube into the antenna mount.
iMpoRtant
Leave the excess receiver antenna wire hanging from the top of the antenna support tube. Under no circumstances
should you cut the antenna wire shorter.
step 4: checking the steeRing and thRottle contRols
q
Verify that the receiver power switch is in the OFF position.
iMpoRtant
ON and OFF labels are moulded into the face of the switch.
Summary of Contents for Rage
Page 18: ...Page 18 NOTES ...
Page 19: ...Page 19 NOTES ...
