Page
o
Rotate the transmitter's steering wheel backward (to the left). The
Rage 1/18th 4WD Electric Off Road Truck's front wheels should turn
left.
o
Now, let go of the steering wheel. The Rage 1/18th 4WD Electric Off
Road Truck's wheels should return to centre.
iMpoRtant
If the wheels do not point straight ahead (centre) after
you return the steering wheel to centre, turn the steering trim dial
on the transmitter right or left to adjust the wheels so that they point
straight ahead.
o
While holding the Rage 1/18th 4WD Electric Off Road Truck off the
ground, pull back on the throttle trigger. The wheels should spin
counter-clockwise.
o
Release the throttle trigger and the wheels should stop spinning.
iMpoRtant
If the wheels don't spin counter-clockwise, flip the
throttle reversing switch on the transmitter to change the direction
that the wheels spin.
To ensure that the radio control system is operating properly and to prevent any chance of a runaway model, the radio control system
should be range checked before the first run of the day and/or after a crash. To range check the radio control system, do the following:
o
Verify that the transmitter antenna is fully retracted, then turn on the transmitter, then the receiver. With the Rage 1/18th 4WD Electric
Off Road Truck on the ground walk away from it about 10 metres (25 feet). Move the steering wheel while looking at the Rage 1/18th
4WD Electric Off Road Truck's front wheels. The wheels should pivot back and forth as you rotate the steering wheel back and forth.
before running your Rage 1/18th 4wd electric off Road truck, make sure to fully extend the transmitter antenna.
iMpoRtant
If the radio system does not operate properly, please refer to the troubleshooting guide on page 13 before continuing
further. Never attempt to operate your Rage 1/18th 4WD Electric Off Road Truck if the radio control system is not functioning properly.
step 5: Range checking the Radio contRol systeM
Driving your Rage 1/18th 4WD Electric Off Road Truck is the fun part! You will find the that it's capable of awesome speed and has great
handling ability for such a small size. Here are some quick tips:
l
Turning the steering wheel left and right causes the Rage 1/18th 4WD Electric Off Road Truck to turn left and right.
l
To make the Rage 1/18th 4WD Electric Off Road Truck move forward, pull back on the throttle trigger.
l
Letting go of the throttle trigger will cause the Rage 1/18th 4WD Electric Off Road Truck to coast until it eventually stops.
l
Pushing on the throttle trigger will engage the Rage 1/18th 4WD Electric Off Road Truck's braking feature.
l
To engage the Rage 1/18th 4WD Electric Off Road Truck's reverse feature, first push the throttle trigger forward to engage the brakes,
then release the throttle trigger momentarily and push the throttle trigger forward again to go in reverse.
l
The steering and throttle controls are proportional. This means that the Rage 1/18th 4WD Electric Off Road Truck's steering and throttle
controls will react in direct proportion to the amount you turn the steering wheel or move the throttle trigger.
l
If the Rage 1/18th 4WD Electric Off Road Truck veers off to one side or the other on a flat surface without moving the steering wheel,
adjust the steering trim dial on the transmitter until it drives in a straight line.
l
If the Rage 1/18th 4WD Electric Off Road Truck moves without moving the throttle trigger, adjust the throttle trim dial on the transmitter
until it does not move when you're not moving the throttle trigger.
step 6: dRiVing youR Rage 1/18th 4wd electRic off Road tRuck
o
Reinstall the body onto the chassis, using the four clips provided. Remember to install the four circular foam pads between the body
posts and the body.
Summary of Contents for Rage
Page 18: ...Page 18 NOTES ...
Page 19: ...Page 19 NOTES ...