Page 0
STEP 3: CHECKIng THE STEErIng AnD THrOTTlE/BrAKE COnTrOlS
q
With both the transmitter and the receiver turned on, rotate the
transmitter's wheel forward (to the right). The
X
ST 4WD Truggy RTR's
front wheels should turn right.
IMPORTANT:
If the wheels don't turn right, use the transmitter's
servo reversing function to change the direction that the front wheels
turn. Refer to the transmitter's User Guide for more information.
PRO TIP:
We suggest doing the steering tests with the
X
ST 4WD Truggy RTR's front wheels lifted off the ground. This will allow the
steering system to operate smoothly, without any binding.
q
Rotate the transmitter's wheel backward (to the left). The
X
ST 4WD
Truggy RTR's front wheels should turn left.
q
Now, let go of the transmitter wheel. The
X
ST 4WD Truggy RTR's
wheels should return to centre.
IMPORTANT:
If the wheels do not point straight ahead (centre) after
you return the transmitter wheel to centre, use the transmitter's trim
function to adjust the wheels so that they point straight ahead. Refer
to the transmitter's User Guide for more information.
q
Pull back on the throttle trigger. The carburettor barrel should open
completely and the brakes should be disengaged (i.e., the
X
ST 4WD
Truggy RTR should roll forward smoothly when pushed).
q
Let go of the throttle trigger and the carburettor barrel should return to
its idle position - open about 1mm / 1/16". The brakes should still be
disengaged, too. If the brakes are not disengaged when the throttle is
at the idle position, see page 19 "Adjusting the Brake Linkage".
IMPORTANT:
If the carburettor barrel does not open when you
pull back on the throttle trigger, use the transmitter's servo reversing
function to change the direction. Refer to the transmitter's User Guide
for more information.
PRO TIP:
If the carburettor barrel does not open completely, use the transmitter's trim function to adjust the throttle until the carburettor
barrel opens completely when you pull back fully on the throttle trigger. Refer to the transmitter's User Guide for more information.
q
Push the throttle trigger forward. The carburettor barrel should stay
in the idle position (open about 1mm / 1/16") and the brake linkage
should move forward and engage the brakes (i.e., the
X
ST 4WD Truggy
RTR will not be able to roll at all when pushed).
q
Let go of the throttle trigger and the brakes should disengage.
IMPORTANT:
If you need to adjust the brake linkage, see page 19
"Adjusting the Brake Linkage".
