33
Figure 5-5 Sample of EPB function (screen 2)
4.
Wait until the message of ‘
Successful operation
’ popes up. And press
OK
to exit the menu.
5. Enter the
Exit maintenance mode
menu and wait until the message
of ‘‘
Successful operation
’ popes up.
5.3 SAS
Steering Angle Sensors (SAS) System Calibration permanently stores the
current steering wheel position as the straight-ahead position in the SAS
EEPROM. Therefore, the front wheels and the steering wheel must be set
exactly to the straight-ahead position before calibration. In addition, the VIN
is also read from the instrument cluster and stored permanently in the SAS
EEPROM. On successful completion of calibration, the SAS fault codes will
be automatically cleared.
To reset the steering angle, you need to first find the relative zero point
position for the car to drive in a straight line. Taking this position as a
reference, the ECU can calculate the accurate angle for left and right
steering.
After replacing the steering angle position sensor, replacing steering
mechanical parts (such as steering gearbox, steering column, end tie rod,
