45
COMPLIANCE INFORMATION
FCC COMPLIANCE
FCC ID:
2AW3IF500
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1)
This device may not cause harmful interference
2)
This device must accept any interference received, including interference that may cause undesired operation.
Warning
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate
the equipment.
Note
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates
,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
⚫
Reorient or relocate the receiving antenna.
⚫
Increase the separation between the equipment and the receiver.
⚫
Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
⚫
Consult the dealer or an experienced radio/TV technician for help.
Specific Absorption Rate (SAR) information
This device meets the government's requirements for exposure to radio waves. The guidelines are based on standards that were
developed by independent scientific organizations through periodic and thorough evaluations of scientific studies. The standards
include a substantial safety margin designed to assure the safety of all persons regardless of age or health. FCC RF Exposure
Information and Statement the SAR limit of the USA (FCC) is 1.6 W/kg averaged over one gram of tissue. Device types: This device
has also been tested against this SAR limit. This device was tested for typical body-worn operations with the back of the tablet kept
0mm from the body. To maintain compliance with FCC RF exposure requirements, use accessories that maintain an 0mm separation
distance between the user's body and the back of the tablet. The use of belt clips, holsters and similar accessories should not contain
metallic components in its assembly. The use of accessories that do not satisfy these requirements may not comply with FCC RF
exposure requirements, and should be avoided.
CE
Declaration of conformity
Herby, Shenzhen XTOOLtech Intelligent Co., Ltd declares that this Car Diagnostics Tablet
,
F500 is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. In accordance with Art
icle 10(2) and Article 10(10), this product allowed to be used in all EU member states.
UKCA
Herby, Shenzhen XTOOLtech Intelligent Co., Ltd declares that this Car Diagnostics Tablet
,
F500 satisfies all the technical regulations applicable to the product within the scope of UK Radio Equipment Regulations (SI 2017/
1206); UK Electrical Equipment (Safety) Regulations (SI 2016/1101); and UK Electromagnetic Compatibility Regulations (SI 2016/1
091) and declare that the same application has not been lodged with any other UK Approved Body.
