67
Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy
and, if not installed and used by the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Specific Absorption Rate (SAR) information
This device meets the government's requirements for exposure to radio
waves. The guidelines are based on standards that were developed by
independent scientific organizations through periodic and thorough
evaluations of scientific studies. The standards include a substantial safety
margin designed to assure the safety of all persons regardless of age or
health. FCC RF Exposure Information and Statement the SAR limit of the
USA (FCC) is 1.6 W/kg averaged over one gram of tissue. Device types:
This device has also been tested against this SAR limit. This device was
tested for typical body-worn operations with the back of the tablet kept
0mm from the body. To maintain compliance with FCC RF exposure
requirements, use accessories that maintain an 0mm separation distance
between the user's body and the back of the tablet. The use of belt clips,
holsters, and similar accessories should not contain metallic components
