Chapter 2
Embroidery Guide
Owner’s
Manual of BECS- A15 Computerized Control System
19
2.4
Normal Embroidery, Returning and Patching
In embroidery confirmation status (
is displayed), press
to start
normal embroidery, and during embroidery, press
to stop embroidery.
When the machine stops, press
to return the frame back along with the original
embroidery path; one press, one stitch back; hold pressing for 2s to return continuously,
even without holding
; press
again to stop.
The purpose of returning is for patching, and when the machine stops returning, press
to start normal embroidery.
2.5
Embroidery Operation
When the machine stops, press
to start embroidery;
When the machine is embroidering, press
to stop embroidery.
2.6
Thread-Breakage Detection
Based on different working principles, thread-breakage detection devices have three
types: thread take-up spring type, thread winding wheel (chopper wheel) type and mixed
type.
For thread take-up spring type, it detects the thread-breakage by searching connection
of take-up spring and contact point. When thread breaks, the spring will close to the contact
point. In normal condition, this detecting type is sensitive to the face thread breakage, but
can hardly detect bobbin thread run-out. In case you change the embroidery thread, or
thread tension
