Install dropout fixing bolts
s
tep 3
3A: Attach the Leap frame to the bike frame, by
inserting the dropout fixing bolts into the rear
dropouts of the bicycle as shown.
The curved side of the dropout insertion tab needs
to be placed into the dropout. You can get it to sit
the opposite way but it will not seat fully causing
issues.
•
Check that the tabs on the dropout fixing bolt
heads can fully seat into the dropout.
Note:
This step may be easiest to accomplish with
the bike upside down.
3A
3A
3B: Adjust the length
of the extension tube
until it aligns with the
extension tube bracket
on the clamping plates.
•
Temporarily place
the shorter M10
carriage bolt through
the bracket and
extension tube as a
pin to hold in place.
3B
3C: Use a 17mm
wrench to tighten both
dropout fixing bolts to
30-40 N-m.
Note:
If you turned the
bicycle upside down,
you may now turn it
right side up again.
3C
Dropout
Carriage
Bolt
