Clip each of the two side buckles around the corners of
the V-Rack. The forward buckle should loop below the
Wedding Rings (shown in Step 5). Do not tighten yet.
Position the four Ladder Locks facedown as shown. For
EdgeRunners use the #2 position for the two outside
Locks and #3 potition for the two inside. On Stoker and
Leap models you may have to adjust these at Step 5.
Install the hook-and-loop straps through the two outer
ladder loops. On EdgeRunner models, use the #1 opening.
On Leap & Stoker models use the loop at the center of
the V-Rack depending on the height of the V-Rack
1
2
3
4
Clip the four upper buckles around the top of the V-Rack.
Installing the X3 CargoBay
Longtail CargoBay
Installation Manual
Use t
his manual for installation
of a X3 series CargoBay on
your Edgerunner, Stoker or Leap
