2
Thread pointed end of webbing through each Ladder
Lock and cinch down tightly.
Make sure side buckle webbing is not binding at the top
of the V-Rack. Pull webbing attached to side buckles as
far down as you can. Cinch strap on the backside of the
CargoBay to tighten.
Go back and tighten all straps until the bag is firmly
tensioned around the V-Rack and lower bike frame.
Tie off any extra webbing.
Attach the two middle Ladder Locks around bottom
tubing of the bike frame and cinch down snug.
7
8
10
9
Center the CargoBay on the V-Rack and pull the hook-
and-loop straps taut around the two uprights of the
V-Rack.
Note: The forward strap should attach below the
Wedding Ring on an EdgeRunner model
Wrap the nylon webbing attached to the forward and
rear Ladder Locks around the back side of the lower bike
frame.
Note: If you are installing on a Leap the front nylon
webbing will feed through a gap on the kickstand plate.
5
6
Longtail CargoBay
Installation Manual,
Continued
