12
41
Using a 4 mm Allen wrench, remove the top of the clamp
located on the back end of the FootRest. Keep the top of the
clamp and the hardware nearby.
40 - Install the RFA FootRests
Pick the RFA FootRest that corresponds to the side of the
bike you are installing it on first. The flat plate is installed
on the bike frame towards the front of the bike and the
clamping ring is installed around the UtilityRack toward the
rear of the bike.
Right FootRest
Left FootRest
front
mounting
plate
rear
mounting
clamp
43
Remove the WheelSkirts.
Locate the installation front threads on the bike frame.
42
To ensure the holes in the FootRest mounting plate line up
with the mounting holes in the frame, you will need to loosen
the bolts securing the UtilityRack to the frame. Using a
5 mm Allen wrench, loosen these four bolts (two on each
side). There only needs to be a little bit of play in the rack. Do
not tighten these bolts down again until the FootRests are
fully installed.
Summary of Contents for RFA
Page 1: ...RFA assembly Manual ...
Page 15: ......
