Xtracycle RFA, Assembly Manual

6

17

It is important to start this off with just your fingers to help  
insure that you do not cross thread the bolt since you may be 
coming at it from an off angle.

Once the first bolt is secured loosely, mount the second bolt 
to the opposite front boss.

16

Place two washers on one of the M8 bolts. Starting on the 
inside of the mounting plate and using just your fingers, 
thread the bolt with the washers to the front boss until you 
can not turn it any further. You should be able to thread the 
bolt until you are certain it has engaged with the threaded 
boss on the chainstay. 

18

Make sure the holes in the mounting plate on the rear of the 
KickBack line up with rear threaded bosses before tightening 
all the way. Using the ball or short end of the Allen wrench 
tighten the two front bolts. 

19

Place two washers on one of the M8 bolts. Starting on the 
inside of the mounting plate and using just your fingers, 
thread the bolt with the washers to the rear boss until you 
can not turn it any further. Once the first bolt is secured 
loosely, mount the second bolt to the opposite rear boss.