10
33
Determine if you would like to have the U-tubes installed in
the wide setting (shown on the left side of the bike pictured
below) or the narrow setting (shown on the right side). In the
wide setting, the U-tubes will extend 6" out from the frame. In
the narrow setting, they will extend 5.25" out from the frame.
If you would like to switch the width setting
on your U-Tubes to narrow or wide:
Press the spring pin button in and push or pull the spring pin
elbow on the inside of the U-Tube until the spring pin button
pops out and into the setting hole. Needlenose pliers might
be needed to help with this.
34
Check to see if the U-tubes will fit into the frame. If they
comfortably slide into the holes, skip to step 36.
Narrow
setting
hole
Wide
setting
hole
32 - Install the U-Tubes
Before installing the U-Tubes, please take note that the
rear insertion end on each U-Tube is slightly longer than the
insertion end on the front end of the U-Tube.
Front
insertion
end
Rear
insertion
end
Summary of Contents for Stoker 2021
Page 1: ...stoker assembly Manual 2021 ...
Page 13: ......
