Operation Manual
45
XR5519
Operator Cab
Boom Angle Indicator
The boom angle indicator is located on the left side of the
boom and is visible from the operator’s seat. Use the boom
angle indicator to determine the boom angle when referring
to load capacity charts. Refer to the LOAD CAPACITY CHARTS
section of this manual for more information.
NOTE: The boom angle indicator is a plumb arrow with
angular graduations from -2.30 to +690
Fig 63. Boom Angle Indicator
Boom Extend Letters
As the boom is extended, the boom extend letters on the left
side of the boom are visible to the operator. These letters
indicate boom extension as it corresponds to the load capacity
charts.
Fig 64. Boom Extend Letters
Frame Level Indicator
The frame level indicator is mounted on the upper right
corner of the operator’s cab. The frame level indicator allows
the operator to view if the forklift has been positioned in a
level condition.
Fig 65. Frame Level Indicator
Boom Maintenance Stand (Optional)
The Boom Maintenance Stand is used to support the boom
during any and maintenance activities where the boom is
raised.
•
When preparing to set boom stand, make sure machine
is on a flat level ground and machine has no load on the
forks.
•
Raise machine boom to 40 degrees for clearance and
remove latch and pin from boom stand weldment.
•
Position the boom stand in the upright position and re-
apply the pin to secure stand.
•
Proceed by slowly lowering machine boom to lay on
stand.
When not in use, fold the support down and latch it in place.
•
When preparing to remove boom stand, make sure all
maintenance has been performed and area is clean.
•
Raise machine boom to 40 degrees for clearance and
remove pin from stand weldment
•
Lay boom stand in the down position and re-latch stand
to secure.
