Operation Manual
49
Operation
Functional Test Checklist
Warning
Perform a pre-operation inspection and func-
tional tests at the beginning of each work
shift. Perform the pre-operation inspection
first. DO NOT perform the pre-operation
inspection with the engine running or hot.
Contact with moving or heated parts could cause death or
serious injury.
Perform the pre-operation inspection and
functional tests in an open area and away
from any other obstacles or equipment. In-
spections and functional tests may require
assistance. Keep the assistant visible and a
safe distance from the Telehandler to prevent death or se-
rious injury.
If anything is found to be in need of repair or
maintenance, defective, or unsafe in any way,
remove Telehandler from service and place
“Do Not Operate” tags on the starter switch
and steering wheel.
The safety, efficiency, and service life of your Telehandler
will be increased by performing functional tests at the
beginning of each shift. If any of the items in the functional
tests are not operating properly or within set tolerances,
stop the Telehandler, follow proper shut down procedures,
tag the Telehandler with “Do Not Operate” tags, and have a
qualified mechanic service or repair the Telehandler before
placing it into service again.
Operate the boom control handle forward and
backward to lower and raise boom.
Operate the boom control handle left and right to
retract and extend boom.
Operate the attachment tilt thumb stick up and down
to tilt the attachment.
•
Apply the service brake pedal after the Telehandler
begins to move and the Telehandler should stop
immediately.
•
Apply the parking brake. The Telehandler should
not move unless the parking brake is released.
Test each steering function. Operate the Telehandler
in forward and reverse at low idle speed and turn the
steering wheel approximately 1/4 turn in each direction
for each of the following modes:
•
Align the wheel and set the Steering Select switch
to crab steering.
•
Align the wheel and set the Steering Select switch
to 2 wheel (2W) steering.
•
Align the wheel and set the Steering Select switch
to 4 wheel (4W) steering.
Check the gauges after the engine warms to the proper
operating range.
•
Check the voltage gauge. The voltage gauge
should read between 11 and 15 volts.
•
Check the engine coolant temperature gauge. The
engine coolant temperature gauge should read be-
tween180 to 2000F.
•
Check the engine oil pressure gauge. The engine
oil pressure gauge should read between 40 to 80
PSI.
Operate the sway control handle left and right to frame
sway left or right.
Operate the auxiliary attachment control (if an auxiliary
attachment is being used).
Turn work lights on and off.
Press the horn button to sound the horn.
Place the travel select lever in reverse to sound the
backup alarm.
Release the parking brake.
Operate the Telehandler in forward and reverse.
Test the service and parking brakes.
