Operation Manual
47
XR630
Operation
Lead-acid batteries produce flammable and potentially ex-
plosive gases. To avoid death or serious injury when check-
ing, testing, or charging batteries:
•
DO NOT use smoking materials near batteries.
•
Keep arcs, sparks, and open flames away from batteries.
•
Provide ventilation for flammable vapors.
•
Wear proper personal protective equipment, including
safety glasses.
Fluid in electric storage batteries contains sulfuric acid,
which is poison and could cause severe chemical burns.
Avoid all contact of fluid with eyes, skin, or clothing. Use
protective gear when handling batteries. DO NOT tip a bat-
tery beyond a 45° angle in any direction.
If contact does occur, follow these First Aid suggestions:
•
External contact - Flush with water.
•
Eyes - Flush with water (including under the eyelids)
for at least 15 minutes and get medical attention
immediately. Flushing must begin immediately to
avoid permanent eye tissue damage.
•
Internal contact - Drink large quantities of water or milk
to dilute stomach contents. Do not induce vomiting.
Get medical attention immediately.
IMPORTANT - In case of internal contact, DO NOT give fluids
that induce vomiting.
Warning
Battery posts, terminals, and related
accessories contain lead and lead
compounds, chemicals known to the State
of California to cause cancer, birth defects, or
other reproductive harm. Wash hands after
Warning
handling these items.
California Proposition 65
Warning
Wear eye protection when starting a Telehan-
dler with jump start cables. Improper jump
start procedures could cause the battery to
explode, which could result in death or seri-
ous injury.
•
Never jump start a frozen battery, as it can explode. Let
the battery thaw out before charging.
•
NEVER jump start the Telehandler when travel select le-
ver is in gear, which can cause the Telehandler to lurch
forward or backward, and could result in death, serious
injury, or property damage.
•
To avoid injury or death when jump starting with an-
other Telehandler, make sure the two (2) Telehandlers
are not touching.
•
DO NOT allow jump start cable ends to contact each
other.
•
Connect charged battery positive (+) to stalled battery
positive (+).
•
Connect charged battery negative (–) to stalled Tele-
handler ground. Make the connection to the stalled
Telehandler ground last.
•
Connect jump start cable to stalled Telehandler ground
a safe distance from the battery to prevent sparks near
the battery.
•
Jump start only with a power source with the same volt-
age as the stalled Telehandler.
•
Turn off all lights and accessories on the stalled Tele-
handler to prevent them from operating when the pow-
er source is connected.
•
Electrolyte contains acid and could cause serious
personal injury if it contacts the skin or eyes.
Caution
Use caution when operating the forklift
during storms or strong winds.
