Walk-behind floor scrubber -www.xtremepolishingsystems.com
push ensure stopping machine
Make sure you connect the terminals marked with a "+" to the positive poles of the battery.
Do not check the battery charge by sparking.
Follow the instructions given below meticulously as short circuiting the batteries could
cause them to explode
。
1)
Make sure the recovery tanks is empty
。
2)
Release the recovery tank from the detergent tank by pulling the catch( ref pic 10).
pic
(
10
)
3)
Lift the dirty water drum and tilt it backwards by about 90°. This provides access to the
battery compartment (in the detergent tank) from above.
。
4)
Place the batteries in the compartment in the direction shown in the drawing printed
inside the compartment on the detergent tank
。
Mount the batteries on the machine using lifting means suitable for their weight.
The positive and negative poles have different diameters.
4) connect the battery cable and bridge terminals to the battery poles (ref pic 11) and tighten the
terminals on the poles
pic
(
11
)
IMPORTANT
!
DANGER