Walk-behind floor scrubber -www.xtremepolishingsystems.com
Check batter power(please charge first if the power is not enough)
l
Step brush plate footboard to release the font brush plate.
l
Fill with water to the water tank (make sure the recovery tank is empty) before fill
water,please must pay attention to make the solution tank net.
l
Make sure the water drain valve is off.
l
Pick up pad driver with colored cleaning pad or pick frequently-used brush plate depending
on the floor situation.
l
Make sure the squeegee is fast and equipped with suction pipe.make sure the back
squeegee rubber is workable.
INFORMATION
If you are using the machine for the first time, we recommend trying it on a large
obstacle-free surface first to acquire the necessary familiarity.
Always empty the dirty water drum before filling the detergent tank again.
For effective cleaning and to extend the working life of the machine, follow a few simple rules:
•
prepare the work area by removing all possible obstacles;
•
begin working from the furthermost point to avoid walking on the area you have just
cleaned;
•
choose the straightest possible working routes;
•
divide large floors into parallel rectangular sections.
If necessary, finish off by passing a mop or rag rapidly over parts inaccessible
to the scrubber drier.
6.7 start working
after installaton, please do as follows:
*connect machine power
*insert battery connection plug to machine body socket.
*low draw bar of squeegee to low squeegee.
*put footboard of front brush plate,make front brush palte completely touch ground.
*Take out ID cards (as the pictuere (2))shown), stop for 3 seconds on the control panel,when
batter power light is on,put ID card back.