Walk-behind floor scrubber -www.xtremepolishingsystems.com
Picture (20)
*touch water sucntion button and brush motor button successively, start working right now.
*control operation handle to go forward to clean ground.
*After bush motor button pressed,the motor start drive brush plate, machine go forward.
Machine go forward with the force that generated between brush plate and ground.
when touch the brush motor button again, It will stop working,touch suction motor switch
again, suction will stop working.
when forward direction is away straight line,adjust with direction adjustment button.
when machine deflect right,adjust by clockwise rotating; or eles adjust by unclockwise rotating.
(as picture(22) shown).
l
Regularly check whether water in water tank with water flowing to the brush plate. Add
water when water tank is empty. When water in water tank of water is not enough, LED
light on water tank level indicator will light up to alert the operator. At this time,stop the
machine and empty the solution tank and add water to solution tank.
l
During cleaning, check the cleaning effect. Rotate the drain valve to adjust water yield
depending requirement.
l
adjust working pressure by adjusting Knob. Uncover the water tank, you can see this knob.
Rotate clockwise to increase pressure, counterclockwise rotation can reduce stress.
IMPORTANT
Empty the dirty water drum each time you fill the detergent tank. Never leave the suction
motor on and detergent tap open when parked.
•
when the dirty water drum is full, the level indicator comes on and after a few seconds the
suction motor shuts off. You must stop working and empty the tank. To restart the suction
motor, turn the suction switch off and then on again.
l
When the yellow LED light starts blink,it means the battery power is almost exhausted.
Should immediately turn off the brush motor and dry ground as soon as possible.later
close suction motor to avoid excessive battery discharge. Please charge the battery
immediately.
The final cleaning:
l
Closev water drain valve.
l
Let suction motor continues to work for 2 seconds to dry sewage inside squeegee . Then
touch suction motor button to stop suction motor.
l
Close brush motor and suction motor switch,and touch Stop button to close them all.
l
Lift the squeegee lever to lift the squeegee, to avoid squeegee pressure to the ground
cause strip deformation.
l
Uninstall brush plate or pad driver from scrubber to avoid distortion.