Walk-behind floor scrubber -www.xtremepolishingsystems.com
·
lower the squeegee by means of the corresponding lever; picture 31
·
remove the squeegee from its mount by completely unscrewing the two knobs
·
remove the suction hose sleeve from the squeegee;
·
release the catch;
·
remove the two blade retainers by first pushing them towards the body of the squeegee then
extracting them;
·
remove the blade; picture 32
·
reuse the same blade by reversing the edge in contact with the floor until all four edges are
worn out, or replace with a new blade, fitting it onto the screws on the body of the
squeegee;
·
reposition the two blade retainers by centring the widest part of the slots over the fixing
screws on the squeegee body, then pushing the blade retainers inwards;
·
refasten the catch.
Replace the squeegee in its support following the instructions in paragraph
Squeegee
Picture
（
31
）
1 2 3 4
5 6 7 8
9 10 11 12
13 14 15
Picture 32
blade
blade
wheels
Kno
b
key
