Walk-behind floor scrubber -www.xtremepolishingsystems.com
9.5
Fuses: replacement
The fuses protecting the brush and suction motors are located in the fuse holder attached to the
dirty water drum above the machine battery compartment.
To replace the fuses:
make sure the dirty water drum is empty and empty if necessary;
raise the dirty water drum;
raise the fuse holder cover and remove the fuse by unscrewing the fixing screws; picture
33
fit a new fuse and close the fuse holder cover;
lower the dirty water drum.
Fuse table:
For the complete fuse table, see the spare parts catalogue.
Picture
（
33
）
Never use a fuse with a higher amperage than specified.
If a fuse continues to blow, the fault in the wiring, boards (if present) or motors must be identified
and repaired. Have the machine checked by qualified personnel.
9.6.
Routine maintenance
9.6.1 Daily operations
After each day's work, proceed as follows:
·
disconnect the machine from the power supply;
·
empty the dirty water drum and clean if necessary;
·
clean the squeegee blades and check for wear. If necessary, replace.
·
check that the suction hole in the squeegee is not blocked. If necessary
remove encrusted dirt;
·
recharge the batteries according to the procedure described.
9.6.2 Weekly
Warning
