Walk-behind floor scrubber -www.xtremepolishingsystems.com
·
Clean the dirty water drum float switch and make sure it is working correctly;
·
clean the suction air filter and make sure it is undamaged. If necessary, replace.
·
clean the detergent filter at the front opening of the detergent tank and check that it is not
damaged (replace if necessary);
·
clean the suction hose;
·
clean the dirty water and detergent tanks;
·
Battery model:
check the level of battery electrolyte and top up with distilled water if
necessary.
9.6.3. Six monthly operations
10.Trouble solution
10.1
How to resolve possible problem
problem
cause
remedy
The machine
does not
function
Batteries
connector
disconnected
connect the batteries to
the machine.
Batteries are flat.
Recharge the batteries.
Brushes do not
work
Brush motor does not turn
on.
Start the motor switch
the motor thermal cutout
has tripped; the motor is
overheated
release the brush lever,
turn off the brush switch;
leave the machine to cool
down for at least 45
minutes
the power supply of
motor
thermal
cutout
connectors
are disconnected
Reconnect the power
supply or connect motor
thermal cutout
the brush motor fuse has
blown
fuse has blown.
heck
and eliminate the
causes responsible for
blown fuse, then replace
Batteries are flat
Recharge the batteries
the reduction unit is faulty
Replace the reduction unit
replaced
the motor is faulty
Replace the motor
The machine does
not clean evenly
the brush or disks are worn Replace them
install
the
brushes
improperly
Install the brushes
properly